Build your own indoor drone with a real gripper arm. Pick up objects, fly missions, compete with friends. No programming — kids use AI to write all the code.
A real drone with a real gripper. Not a toy.
Start easy. Get harder. Each mission unlocks the next.
Assemble the frame, mount the motors, connect the electronics. Your drone, built by you.
Take off, hold steady, and land on the target zone. Sounds simple? Try it.
3D-print the gripper parts, run the tendon cables, mount the servos. Mechanical engineering — your hands.
Fly to the ball, grab it mid-air, bring it back. First real grab — you'll remember this one.
500g payload. Your drone at max capacity. Pick up, fly steady, set down on target. No spills.
3 objects, 3 drop zones, 1 battery. Collect them all before your power runs out. The final test.
Real engineering. Not a follow-the-instructions toy.
Frame, motors, electronics, gripper — all assembled by the kid. No pre-built modules, no shortcuts.
A real mechanical gripper with Dyneema tendon cables and servo motors. Grips up to 500g — enough for a water bottle.
Full propeller guards on all four arms. Indoor-safe. Kid-safe. Parent-approved.
Gripper fingers, base plate, tendon guides, servo spools, and landing gear extensions. All 3D-printed, all included.
Created by a mechanical engineering graduate from RWTH Aachen. Every part tested, every tolerance checked.
Every screw, every cable, every propeller. Plus battery, charger, and remote control. Nothing extra to buy.
Everything you need. Nothing you don't.
First batch is limited. Reserve your kit now or get notified when we launch.